• -12%
  • New
12V/100AH - MM 335x174x191

12V/100AH - MM 335x174x191

12V/100AH - MM 335x174x191
RELION
3940903
€1,321.35
€1,162.78 Save 12%
Tax included
Add to Wishlist
Add to Compare
Product temporarily out of stock. Delivery waiting time up to 2 weeks

 

Simple and fast returns within 14 days

 

Shipping throughout Italy max 4 days

 

Deferred payment, C/C and Bank transfer

RELiON lithium batteries provide more power than lead-acid batteries, increase performance and weigh half as much.They can be charged quickly, but a slower charging rate of e.g. 2-5 hours is recommended.Unlike other batteries, leaving them partially discharged does not reduce their life or long-term performance. Their charging capacity isabout 25-50% higher than other models, which ensures prolonged use of the equipment and avoids voltage drops as the charge decreases.Maintenance-free, they last up to 10 times longer than their lead-acid counterparts, while retaining 80% of capacity after 2000 cycles. They aremore temperature tolerant, being able to operate safely up to 65°C and offer higher performance at low temperatures.Series or parallel connectionsWhen connecting batteries in series or parallel, please observe the following guidelines:(1) Before putting them into service, ensure that each battery does not exceed 50mV (0.05V). This will minimise the possibility of imbalancebetween the batteries. If they become unbalanced, the voltage of any battery is >50mV (0.05V), relative to another in the set, each battery mustbe individually charged to rebalance. (2) Size the batteries in parallel appropriately: the capacity (rated in hours) when connected in parallelincreases by the multiple of the batteries connected (2x, 3x, 4x, etc.). However, the nominal current (discharge and charge) of the batteries inparallel only increases by 75% of the multiple of the connected batteries (1.5x, 2.4x, etc.) (1.5x, 2.25x, 3x, etc.). (3) Batteries connected in seriescharge better as single batteries. Series charging can cause imbalances and reduce operating time, requiring an occasional individual balancingcharge. (4) Please refer to the RELION document on instructions for series and parallel charging.Discharging the LiFePO4 batteryLiFePO4 batteries can be discharged up to 100% of their capacity. However, to optimise performance and prevent the BMS from disconnectingit, it is recommended to limit discharge to 80%. Please refer to the battery’s data sheet for the continuous and peak discharge rates of thespecific model.When to charge the LiFePO4 batteryIf LiFePO4 batteries are not fully discharged, it is not necessary to charge them after each use, they will not be damaged if left in a partial stateof charge (PSOC). They can be charged after each use or when they have been discharged to 80% (20% SOC). If the BMS disconnects thebattery due to low voltage, at 100% discharge, remove the load to reconnect the battery circuit and charge immediately. It is recommended tostore batteries at 50% state of charge (SOC).Use compatible chargers for lithium batteries, such as ProMariner. When charging from an alternator, check that it is compatible andhas the correct charging parameters.
RELION
3940903